How to Use SmartTract Go: Automatic ED Pump Guide
How to Use the SmartTract Go Automatic ED Pump
SmartTract Go is the only automatic, app-tracked ED pump in the category. Here is a clear, step-by-step guide for your first session. You can run sessions with the SmartTract app for guided routines, or app-free in manual mode.
Before you start
- Make sure your SmartTract Go controller is fully charged.
- Pick the cylinder size that matches your measurements (use the on-product size guide if needed).
- Have the included water-based lubricant within reach.
- Optional: install the SmartTract app from the App Store or Google Play.
Step-by-step
- Attach the seal ring to the cylinder base for an airtight fit.
- Apply lubricant to the seal ring and the base of the shaft. This is what makes the seal comfortable and airtight.
- Connect the controller to the cylinder. You will hear a click when it locks in.
- Place the cylinder over the shaft, pressing gently against the body until it seals.
-
Start a session.
- With the app: open the SmartTract app, select a guided routine, and press Start.
- Without the app: press the power button on the controller to begin in default automatic mode.
- Let the device run. SmartTract Go automatically controls pressure and timing throughout the session. No squeezing or hand pumping required.
- End the session. Press the release button on the controller. The vacuum will safely vent.
- Clean and store. Rinse the cylinder and seal ring with warm water. Air dry. Store everything in the included travel case.
How often should you use it?
Most users start with three to five sessions per week and adjust based on comfort and goals. The SmartTract app suggests a routine based on your goals when you set it up.
Safety
SmartTract Go is FDA-grade and doctor-approved, but vacuum therapy is not for everyone. If you have a known vascular condition, are on blood thinners, or have any concerns, talk to your doctor before starting.
